Bontrager SPEED LIMIT ROAD BRAKESETS Owner's Manual download pdf (Page 33)

31 TREK SERVICE INFORMATION 24 May 2010

To install the bearings

Apply a liberal coat of grease to the contact surfaces of one bearing and the drive side 1.

of the bottom bracket shell (Figure 11).

With the plastic bearing shield facing out, press one bearing into the drive side of the 2.

bottom bracket shell (Figure 12).

Repeat Steps 1-2 for the other bearing on the non-drive side.3.

To install the drive-side crankarm

Apply a light coat of grease to the axle surface where the bearings will be in contact 1.

(Figure 13).

The grease areas should be about 1 inch (25 mm) wide. On the drive side, start at the

bearing seal. On the non-drive side, start at the splines and apply toward the drive side

of the axle

Insert the axle through the drive-side bearing in the bottom bracket (Figure 14).2.

Figure 13. Greasing the axle

Figure 12. Pressing the bearing into the frame with the

shield on the outside

Figure 11. Greasing the bearing and the frame saddle

Figure 14. Sliding the axle through the bearings

1 2 ... 28 29 30 31 32 33 34 35 36

No comments

Bontrager SPEED LIMIT ROAD BRAKESETS Owner's Manual Page 33