Bontrager SPEED LIMIT ROAD BRAKESETS Owner's Manual download pdf (Page 32)

30 TREK SERVICE INFORMATION 24 May 2010

FSA MegaExo AL

These instructions and parts are for the aluminum FSA cranks only. The current “B” kit will

not work for FSA carbon cranks.

The Speed Concept uses a special bearing system that has no parts that thread into the

frame. Instead, the bearings are a slip-t into the frame (Figure 10). This section explains

how to install the bearings and crankset.

The bearings might t into the frame tightly. In this case, you might need to tap them with

a soft-faced mallet. However, do not use a hammer or bearing press to install the bearings

into the frame. If the bearing t is too tight, make sure the bearings are clean and free of

debris.

Tools and materials required

To complete the installation, you will also need the FSA instructions, available at:

http://www.road.fullspeedahead.com/downloady.aspx?download=downloads/

Install_MegaExoAlloy.pdf.

• Crankset and bearings (bearing shields come pressed onto the bearings)

• 5 mm Allen Wrench

• Rock “N” Roll Super Coat grease

• Bottom bracket parts

Figure 10. FSA bearing set

Bearing with shield pressed on

Part

description

FSA

BB90 bearing kit “B” 293227

Drive side parts

Axle shield 281823

Bearing 300162

Seal 294668

Non-drive side parts

Axle shield 281822

Bearing 300162

Seal 294668

Bearing with shield pressed on

1 2 ... 27 28 29 30 31 32 33 34 35 36

No comments

Bontrager SPEED LIMIT ROAD BRAKESETS Owner's Manual Page 32